In nearly all cases, most people spend quite a lot of money buying their lift truck. Thus, it is extremely important to take good care of it so as to protect your investment well into the long run. It is really a great idea to know the procedures which are carried out during maintaining and taking care of this equipment.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is performing. For instance, if there are any misses or knocks, the equipment is faulty and this should raise some concerns. Additionally listen carefully for any squealing sounds that come from the belts as these sounds would provide you with a wealth of information.
Some of the main parts requiring attention during maintenance consist of the horn, safety warning devices, gauges, the overhead guard and the lights. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals should be cleaned when the above parts have been inspected thoroughly. If the terminals are not clean, be sure to clean them well. Each and every cell of the battery should be checked in order to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and then change the filters. The fuel filters, hydraulic filter and the transmission filter should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change has been carried out and new filters have been fitted, visually inspect the drive axle from underneath the equipment. Be certain to grease the axle if there is any grease fitting. Check the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Then, check each and every other part of the machinery like the wheels. If any kind of issue or fault is detected, be sure to address it immediately so as to make certain the machinery is running at its safest and optimum levels.