Change a Propane Tank
Propane fueled forklifts are normally utilized in warehouses. The lift truck is made with the propane tank mounted behind the driver. The tanks, which look much like beer kegs, need to be replaced from time to time as they have a limited lifespan. Forklift drivers must use caution when handling propane tanks. Compressed gases are hazardous, particularly because the gas is flammable. Always use care when removing and replacing propane tank to avoid being injured.
1 To change a propane tank, first stop the lift truck and leave the engine running, and turn the valve on the tank off. Let the lift truck run until the engine dies. This process burns the gas off inside the transfer hose that connects the engine and the tank. Before taking the second steps, put on the correct safety equipment, like insulated gloves made of either leather or neoprene. It is very essential for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reattach the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 Leaks could be inspected just by applying soapy water to the valve and opening it slightly. If there is a leak, it will cause bubbles to froth from around the valve. If this occurs, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks around the area of the valve, and after that do the leak checking process over again. Persistent leaks mean that the connecting hose and nut should be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Lastly, open the valve all the way to allow the gas to fill the connecting hose. Then you can start the lift truck and continue working.